Fastening / Unfasten Of The Mounting Adapter - Tr-Electronic Lt-Rv Montageanleitung

Mounting

5.4 Fastening / Unfasten of the mounting adapter

 TR-Electronic GmbH 2006, All Rights Reserved
Page 42 of 47
Destruction of the Measuring System in case of improper
mounting!
• If the mounting adapter
may not be transferred to the eccentric rod
loosening the mounting adapter the eccentric rod must be held in place
therefore with a second open-end wrench.
TR - ELT - BA - DGB - 0002 - 06
(A) is screwed in or is unscrewed, the torque
 Screw-on lock nut corresponding to figure (A)
 Screw-in the mounting adapter without force into
the thread of the eccentric rod up to the lock nut
 Hold in place eccentric rod with open-end wrench
(2). Tighten lock nut with open-end wrench (1)
(B) . When tightening or
Printed in the Federal Republic of Germany
10/26/2015