Warranty And Liability; Organizational Measures - Tr-Electronic Lt-Rv Montageanleitung

Basic safety instructions

2.6 Warranty and liability

The General Terms and Conditions ("Allgemeine Geschäftsbedingungen") of TR-
Electronic GmbH always apply. These are available to the operator with the Order
Confirmation or when the contract is concluded at the latest. Warranty and liability
claims in the case of personal injury or damage to property are excluded if they result
from one or more of the following causes:
•
•
•
•
•
•
•
•

2.7 Organizational measures

•
•
•
•
•
•
•
•
 TR-Electronic GmbH 2006, All Rights Reserved
Page 34 of 47
In case of opening of the measuring system, damage of the warranty seal,
any warranty claim expires.
Non-designated use of the measuring system.
Improper assembly, installation, start-up and programming of the measuring
system.
Incorrectly undertaken work on the measuring system by unqualified
personnel.
Operation of the measuring system with technical defects.
Mechanical or electrical modifications to the measuring systems undertaken
autonomously.
Repairs carried out autonomously.
Third party interference and Acts of God.
The Assembly Instructions must always be kept accessible at the place of use
of the measuring system.
In addition to the Assembly Instructions, generally applicable legal and other
binding accident prevention and environmental protection regulations are to
be observed and must be mediated.
The respective applicable national, local and system-specific provisions and
requirements must be observed and mediated.
The operator is obliged to inform personnel on special operating features and
requirements.
The personnel instructed to work with the measuring system must have read
and understood the Assembly Instructions, especially the chapter "Basic
safety instructions" prior to commencing work.
The nameplate and any prohibition or instruction symbols applied on the
measuring system must always be maintained in a legible state.
Do not undertake any mechanical or electrical modifications on the measuring
system, apart from those explicitly described in the Assembly Instructions.
Repairs may only be undertaken by the manufacturer or a facility or person
authorized by the manufacturer.
TR - ELT - BA - DGB - 0002 - 06
Printed in the Federal Republic of Germany
10/26/2015