Safety Information's - Tr-Electronic Lt-Rv Montageanleitung

Basic safety instructions

2.9 Safety information's

•
•
•
•
 TR-Electronic GmbH 2006, All Rights Reserved
Page 36 of 47
Destruction, damage or malfunctions of the measuring system and
risk of physical injury!
De-energize the system before carrying out wiring work or opening and
-
closing electrical connections.
Do not carry out welding if the measuring system has already been
-
wired up or is switched on.
Ensure that the area around the assembly site is protected from
-
corrosive media (acid, etc.).
Avoid any shocks (e.g. hammer-blow) while mounting.
-
Do not open the measuring system.
-
In areas with heavy dust contamination or continuous contact with
-
liquids the measuring system in addition must be protected with an
appropriate covering.
Against shavings, hot metal particles and similar an additional
-
measuring axle protection must be used.
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by an improper use.
Contacts of the measuring system connection contacts with the fingers
-
are to be avoided, or the appropriate ESD protective measures are to
be applied.
Disposal
If disposal has to be undertaken after the life span of the device, the
respective applicable country-specific regulations are to be observed.
Device designs
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here. In case
of doubt, the manufacturer should be consulted, specifying the item
number.
TR - ELT - BA - DGB - 0002 - 06
Printed in the Federal Republic of Germany
10/26/2015