R&G LP0071BK Montageanleitung Seite 2


Disconnect rear light plug socket located under pillion seat.

Disconnect number plate light plug socket located under pillion seat.

Disconnect rear indicator plug sockets located under rider seat.

Unbend cable clips to release wires arrowed below left.

Undo and remove four bolts under pillion seat arrowed below left with 5mm allen key and gently
remove OEM tail-bracket complete with rear light.



Unclip and remove upper rear light cowl.

Undo and remove rear light bolts and cable clips from OEM tail-bracket using 10mm socket and
wrench shown above right.

Fit and secure OEM rear light to new under-tray using longest (M6x35mm long) button head bolts
from kit as original.

If fitting OEM indicators, fit to the new licence plate bracket using adaptors and two M6x20mm
long button head bolts and washers supplied (please note the larger washers go inboard to prevent
indicators pulling through). The adaptors fit between base of indicator and licence plate bracket
(the adaptor allows the indicator to sit level).

If fitting mini indicators we suggest using R&G product code RG370 (you will not require
resistors) and cutting and reusing OEM plug socket.
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
R&G Racing
www.rg-racing.com Email: info@rg-racing.com