Giorik CPG946 Betriebs- Und Wartungsanleitung Seite 15

ADJUSTMENT OF MINIMUM HEAT FLOW
Open the gas tap upstream of the appliance and light the pilot light in the manner indicated in the instructions.
Remove the knob (Fig. 11, ref. 1) and adjust the minimum or bypass screw (Fig. 10 ref. 1): the burner must not go
out and there must not be any fl ashback during a rapid transition from maximum to minimum position. If LPG is
used, the screw must be completely closed.
Check that the fl ame is steady, especially after fast operations with a full fl ame. If the burner goes out or if the
fl ames are too high, adjust in the manner specifi ed above.
2.
The appliance must be used only for the purpose for which it was designed. Any other use is improper.
During operation, supervise the appliance.
2.1 STARTING UP FOR THE FIRST TIME
Before using the appliance for the fi rst time, remove all packing and thoroughly clean all protective grease from
the tank and the receptacles in the following manner:
- Fill the tank to the overfl ow hole with water and normal detergent, switch on and boil for a few minutes;
- drain the water through the drainage tap and rinse the tank thoroughly with clean water;
- never use lumps of detergent salts unless they have been completely dissolved as they could otherwise become
deposited on the bottom of the tank and could in time cause corrosion. Use only fi nes salt (up to 3-mm) and
add it after boiling. If this is not possible, dissolve the salt in hot water beforehand.
2.2 SETTING
Open the water stopcock upstream of the appliance.
Open the water tap (Fig. 11, ref. 2) and fi ll the tank to 50 mm, below the overfl ow level. Make allowances for the
volume of pasta that is to be cooked.
Fig. 10
OPERATING INSTRUCTIONS
1
2
Pag. 15
Fig. 11