Nilfisk Advance BA 410 Betriebsanleitung Seite 62

ENGLISH
AFTER USING THE MACHINE
After working, before leaving the machine:
1. Remove the brush/pad-holder as follows:
• With the brush/pad-holder lifted, turn the brush/pad-holder switch (65) to "I" and, after a few seconds, back to "0", thus
releasing the brush/pad-holder.
2. Empty the tanks (31 and 32) according to the procedure shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee lifted or removed.
RECOVERY WATER TANK REMOVAL
To check or charge the lead (WET) batteries, or to perform other procedures, it may be necessary to remove the recovery water
tank (31) as shown below.
1. Empty the recovery water tank (31) as shown in the relevant paragraph.
2. Drive the machine on a level fl oor.
3. Make sure that the switches (65 and 66) are in the "0" position.
4. Disconnect the vacuum hose (22) from the squeegee (11).
5. Disconnect the recovery water drain hose (16) from the bracket (17).
6. Open the cover (6).
7. Grasp the recovery water tank (A, Fig. 5) in the area (B) and slightly raise it.
8. Disconnect the vacuum hose (C) from the tank, then remove the tank (A) with the hoses (D) and (E).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Remove the recovery water tank (31) as shown in the previous paragraph, and then disconnect the battery negative terminals
(50).
3. Install the recovery water tank (31).
4. Store the machine in a clean and dry place.
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
16
USER MANUAL
B
A
C
D
909 5683 000(2)2007-06 A
E
Figure 5
BA 410
S310233A