Herunterladen Diese Seite drucken

Nilfisk Advance BA 410 Betriebsanleitung Seite 59

Vorschau ausblenden Andere Handbücher für Advance BA 410:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Solution tank fi lling
7.
Use the fi ller neck (45) to fi ll the tank (32) with a solution suitable for the work to be performed. Do not fi ll the solution tank
completely, leave a few centimetres from the edge. Always follow the dilution instructions on the label of the chemical product
used to prepare the solution. The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
Adjustments
8.
Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Lower the squeegee (11) with the lever (19).
3.
Turn the solution fl ow control lever (4) to one of the following positions, according to the type of cleaning to be performed:
ECO system: when the lever (4) is turned to ECO position (5), the machine works in a special condition of programmed
water "economy" usage; as the water fl ow is set and constant, the machine can work with a washing autonomy of 70-80
minutes (0.3 litres/min average).
Variable system: when the lever is turned to the left (variable fl ow) the fl ow rate can increase up to 1 litres/min.
In no case it is possible to close completely the water fl ow to the brushes during operation.
4.
While keeping the hand on the handlebar (2), start the machine by turning the brush/pad-holder switch and the vacuum system
switch (65 and 66) to "I".
NOTE
If the green warning light (62) turns on, the batteries are ready to be used. If the yellow or red warning light (63 or 64)
turns on, the batteries must be charged (see the procedure in the Maintenance chapter).
Stopping the machine
5.
Turn the brush/pad-holder switch and the vacuum system switch (65 and 66) to "0".
6.
Lift the squeegee with the lever (19).
7.
Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).
USER MANUAL
BA 410
909 5683 000(2)2007-06 A
ENGLISH
13

Werbung

loading