Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
To correct, then proceed as follows:
Sensor temperature= 21°C.
(The measured temperature may be different due to the loca-
tion of the thermostat in the room).
Increase the temperature measured by the ambient tempera-
ture sensor by 2°C by pressing
In our example the measured temperature by the sensor goes
from 21°C to 23°C.
To validate, save the new value and exit the mode,
press
. To exit the Expert settings, press
The reset to zero of the sensor calibration
To put the value of the correction to „0", do the following:
1- When the temperature measured by the sensor appears,
press
or
2- To save and move automatically to the next setting press
.
To exit the Expert settings, press
Important:
qualified staff, it should be performed in production or
on site during the first installation.
SETTING THE POWER
To have a controller adapted to the towel rails and estimate the
energy consumed, it is essantial to set the power of the device.
1- Pre set value: 500W. Select a value between 500W and
40
auto
prog
boost
OK
mode
.
auto
prog
boost
OK
mode
for at least 3 seconds.
auto
prog
boost
OK
mode
3 sec.
3 times.
These changes should be performed by a
1500W by pressing
2- To save and move automatically to the next setting
press
3- To save the Expert settings, press
3 times.
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user, installer and
expert settings are reinitialized:
1- From the Power setting setting, press
Rest
appears on the display.
NO
2-
flashes. Press
YES
= Factory settings reset
NO
= Factory settings not reset
or
.
auto
prog
mode
.
auto
prog
mode
auto
prog
mode
or
to select
auto
prog
mode
boost
OK
boost
OK
3 times.
.
boost
OK
YES
boost
OK
Werbung
