Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2- By pressing
or
, you can change temporarily the
desired temperature up to 18°C for example.
auto
3
mode
Note:
The cursor corresponding to the operating mode, i.e
Eco mode in our example, is blinking during the duration of the
temporary derogation.
3- This change will be automatically cancelled at the next
change of programme or transition to 0:00.
auto
3
mode
OPEN WINDOW DETECTION,
ENERGY SAVINGS
Important information about the open
window detection
mportant:
the open window detection is sensitive to tempe-
rature variations. The device will react to the window openings
in accordance with different parameters: temperature setting,
rise and fall of temperature in the room, outside temperature,
location of the device...
If the device is located close to a front door, the detection may
be disturbed by the air caused by opening door. If this is a
problem, we recommend that you disable the automatic mode
open window detection (see page 37). You can, however, use the
manual activation (see below).
2
prog
boost
OK
prog
boost
OK
1
Legend
= the favoured location
= another location
Overview
Lowering temperature cycle by setting frost protection during
ventilation of a room by opened window. You can access the
open window detection from the Comfort, Eco and Auto modes.
Two ways to enable the detector:
- Automatic activation, the lowering temperature cycle starts
as soon as the device detects a temperature change.
- Manual activation, the cycle of lowering temperature starts by
pressing a button.
Automatic activation (factory settings)
To disable this mode, see page 37.
The device detects a temperature fall. An opened window, a
door to the outside, can cause this temperature fall.
Hinweis:
The difference between the air from the inside and
the outside must cause a significant temperature fall to be
perceptible by the device.
This temperature drop detection triggers the change to Frost
Protection mode.
Manual activation
By pressing
for more than 5 seconds, the device will
switch on Frost protection mode.
auto
mode
Frost protection digital meter
When the device performs a lower temperature cycle due to
opened window, a meter appears on the display to show the
cycle time.The counter is automatically reset at the next time
to Frost protection by opened window (automatic or manual
activation).
Stop the Frost protection mode
By pressing one button, you stop the Frost protection mode.
Note:
if a temperature rise is detected, the device may return
to the previous mode (active mode before the open window
detection).
prog
boost
OK
5 Sek.
EN
31
Werbung
