Herunterladen Diese Seite drucken

Purmo FLORES E Montage- Und Betriebsanleitung Seite 25

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION & MAINTENANCE
3.CONNECTIONS
The electrical installation must comply with local or national regula-
tions. This appliance must be installed by a competent electrician.
3.1 ELECTRICAL CONNECTION
The technical characteristics of your appliance are shown on the
data plate located on the side of the appliance. Please take note of
these before any request for After sales service.
Any interventions on electrical parts must be done by a qualified
professional.
Enclosure class IP44,
Connect the 3 core cables as follows:
Brown wire = Live
Blue wire = Neutral
Black wire = Control Wire (Pilot Wire)
This wire must never be connected to the earth and must be
isolated,
RCD of 30mA maximum is compulsary for bathrooms or shower
rooms (must be isolated if not used),
This appliance must be connected to the fixed wiring through a
cable outlet (13A max) and controlled through a double pole swit-
ch having a contact separation of at least 3mm in all poles,
The radiator is supplied with a 0,8 m cord,
Supply voltage 230-240V,
For installation in a bathroom (to comply with current IEE regula-
tions) the appliance must be wired in
the manner prescribed with the double pole switch mounted
outside the bathroom.
If the supply cord on this product is damaged, it must be replaced
by the manufacturer, its service agent, or other qualified person.
This radiator is filled with a precise quantity of liquid, any repairs
that involve opening the radiator must be carried out by the ma-
nufacturer or his service agent. Any leakage must be dealt with by
the manufacturer or his representative.
The factory fitted power cable must be connected to the mains by
a junction box which will have to be placed behind the appliance,
without putting in a power socket and which will be located at
least 250 mm from the floor.
If the supply cable is damaged, it must be replaced by a specific
cable. Replacement of this cable must
be done by the manufacturer, their after sales service or people
with similar qualifications in order to
avoid any danger.
The heated towel rail is filled with an exact quantity of heat trans-
fer fluid. Repairs requiring opening of
the bathroom heater must only be carried out by the manufactu-
rer or their after sales service who must be contacted if there is
any leak of heat transfer fluid.
When the appliance is thrown away, elimination of the heat trans-
fer fluid must only done by approved subcontractors.
4. CONDITIONS OF USE
Refer to the paragraph WARNINGS in point 1. General information
The heater can be used continuously without any risk.
For operating the electronic regulation refer to the operating
instructions.
5.MAINTENANCE TIPS
Maintenance operations must be done with the heater switched off.
Therefore take care the appliance is off. In order to ensure your heater
lasts, we recommend you use the following few tips:
Use only mild cleaning agents when cleaning and wiping of the
radiator is necessary.
Use a dry cloth (without solvent) for the control unit.
Use warm soapy water for cleaning the outside walls of the hea-
ter (no abrasive or corrosive product).
This heating appliance is filled with an exact quantity of glycoled
water depending on appliances. Repairs requiring opening of the
reservoir must only be carried out by the manufacturer or their
after sales service who must be contacted if there is any leak of
glycoled water. This fluid, specially developed for this use does
not require any particular maintenance.
WASTE MANAGEMENT OF ELECTRICAL
EQUIPMENT AND ELECTRONICS IN
ACCORDANCE WITH WEEE DIRECTIVE
2012/19/UE
ROHS: COMPLIES WITH THE DIRECTIVE
2011/65/UE
WASTE DISPOSAL ACCORDING TO THE WEEE DIRECTIVE
(2012/19/UE)
The symbol on the product label indicates that the product may not
be handled as domestic waste, but must be sorted separately. When
it reaches the end of its useful life, it shall be returned to collection
facility for electrical and electronic products. By returning the product,
you will help to prevent possible negative effects on the environment
and health to which the product can contribute if it is disposed of as
ordinary domestic waste. For information about recycling and collec-
tion facilities, you should contact your local authority/municipality or
refuse collection service or the business from which you purchased the
product. Applicable to countries where
this Directive has been adopted.
EN
25

Werbung

loading

Diese Anleitung auch für:

Flores c e