Herunterladen Diese Seite drucken

Purmo FLORES E Montage- Und Betriebsanleitung Seite 38

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

EN
Alternatively, you must copy the steps 1 and 2 of the initiali-
sation process as well as the steps 1 and 2 of the activation
process before personalising the PIN code.
Please remember that the personalisation of the PIN code can
only be set once the initialisation and activation of the PIN code
has been completed.
ON
1- When
appears, press
2- The 0000 code appears and the first number blinks. Press
or
, to select the first desired number then press
to save and exit. Repeat this operation for remaining 3
numbers.
3- Press
to confirm. The new code is now saved.
4- Press again on
back to the home display of the installer settings.
To exit the Installer settings, press
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user and installer
settings are reinitialized:
38
for at least 5 seconds.
auto
prog
boost
OK
mode
auto
prog
boost
OK
mode
1
auto
prog
boost
OK
mode
o exit setting PIN code mode and go
auto
prog
boost
OK
mode
twice.
1- From the PIN code setting, press
on the display.
NO
2-
flashes. Press
5 sec.
YES
= Factory settings reset
NO
= Factory settings not reset
3- Press the key
initial configuration and goes back automatically to the
home display of the installer settings.
2
The following factory values will be effective:
Comfort setting temperature
Boost duration
Keypad lock
Eco mode temperature lowering-level
Frost protection temperature
Minimum set of Comfort setting
temperature
Maximum set of Comfort setting
temperature
Maximal Boost duration
Maximum ambient temperature for
the automatic stop of the Boost
Temperature unit
Automatic open window
detection
PIN code protection
Value of the PIN code
To exit the installer settings, press
Rest
.
auto
prog
mode
YES
or
to select
auto
prog
mode
for 5 seconds. The device returns to its
auto
prog
mode
Settings
Factory settings
Operating
19°C
60 min.
Disabled
User settings
-3,5°C
7°C
7°C
30°C
60 min.
35°C
°C
Installer settings
Enabled
Disabled
0000
twice.
appears briefly
boost
OK
.
boost
OK
boost
OK
5 sec.

Werbung

loading

Diese Anleitung auch für:

Flores c e