eta FENIX Bedienungsanleitung Seite 29

Clean the surface of the vacuum cleaner and adaptor with a soft wet cloth. Do not use any
rough and aggressive detergents!
Accessories
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Floor nozzle with rotary brush / Small turbo brush
Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush with the cleaning tool
L (or other suitable). To make cleaning easier, the brush can be removed (Fig. 9). Now you
may easily clean the brush (rinse it in running water).After wash the roller brush, please dry
the shaft at end of brush (milky plastic location) with damp cloth to avoid rusting. After the
maintenance, apply a reverse procedure to install the brush in the nozzle and secure it.
Do not water the floor nozzle D and the small direct-drive turbo brush G
in running water directly, it will damage motor and PCB.
Dust container
Clean the surface and the inside of the container A4 with a soft wet cloth.
Separator (Fig. 8, 10)
Rinse the separator A8 under running water. Allow the parts to dry out properly before
their re-use.
When removing the filter system (i.e. separator A8, HEPA filter A7)
–
and subsequent cleaning of the container A4, it is necessary to
keep the vacuum cleaner upright and never turn the vacuum
cleaner upside down.
Never rinse the container A4 under running water and never
–
immerse it in water.
HEPA filter (Fig. 8, 10)
Shake out the input HEPA filter A7 gently, or blow it out. Alternatively, use cleaning tool L
to clean it. If the HEPA filter is very dirty, you can rinse it under running lukewarm water.
Hold the filter in such a way that the pleated side points upwards and the water flows
parallel to the pleats. Hold the filter at an angle so that the water washes away the dirt
inside the pleats. Turn the filter 180° and let the water flow along the pleats in the opposite
direction. Continue this process until the filter is clean. After drying, insert the HEPA filter
back to the container in the opposite way.
– Do not clean the filter with any aggressive washing or cleaning detergents or hot water.
– If you clean the HEPA filter with water, its filtration properties will deteriorate. The
filter cannot be washed more than three times. After that, a new filter needs to be purchased
ETA123300010.
– We recommend that you replace the HEPA filter twice a year.
Caution
Caution
Caution
29 / 56
EN