Operating Times; Use Of Vacuum Cleaner (Fig. 4 - 5) - eta FENIX Bedienungsanleitung

The status and progress of charging is indicated by indicator A3.
Flashing blue (the last segment A3) Battery discharged (the device will switch off)
Red light
LEDs D2 go off
Increasing number of blue
flashing segments A3
Blue light segments A3
on continuously
– Let the vacuum cleaner recharge as soon as its suction performance is weaker.
– When using the vacuum cleaner for an extended period of time or in a hot environment, the
accumulator might be too hot for charging. Let the accumulator cool down prior to charging.
– For ensuring longer life of the battery we recommend full discharge and then full
recharge of the battery four times a year.

OPERATING TIMES

Set power
MIN
ECO
MAX
* Note: The stated operating times are based on ETA's internal testing and only apply
to a new and fully charged battery. Depending on the age and wear of the battery, the
operating time decreases.
MOUNTING THE PLASTIC BRACKET TO THE WALL
Mount the plastic bracket I to the wall using the fastener included J, K or a similar fastener
provided by you.
– Make sure that the el. socket is close to the mounted plastic bracket.
– Make sure that no electricity, telephone or water lines etc. are routed under the
plaster near the area where the plastic bracket is mounted to the wall.
IV. USE OF VACUUM CLEANER (Fig. 4 - 5)
Let the vacuum cleaner charge sufficiently prior to using.
CONTROL
Operation signal lights and charging lights (A3)
Clogged input HEPA filter A7 (suction system
clogged)
Rotation brush electronic protection (rotation brush
locked – rotation stopped, the drive continues running)
Accumulator is charging.
Accumulator is charged / indication of operation
(individual segments turn off during operation, as the
battery discharges)
Approx. 40 minutes
Approx. 20 minutes
Approx. 12 minutes
Warning
Running Time *
ETA1233
Caution
27 / 56
EN
ETA2233
Approx. 40 minutes
Approx. 20 minutes
Approx. 12 minutes