Miele PDR 910 G Installationsplan Seite 54

en - Technical data
Possible voltage variants
Supply voltage
Frequency
Power rating
Fuse rating (on site, triggering)
Circuit breaker trip characteristic
Minimum cross-section for connection cable
Air intake
Recommended free air intake cross-section into the room:
(equivalent to 3 times the exhaust air cross-section of an appliance).
There must be sufficient air intake to the installation site to match the air outlet volume.
Exhaust air/exhaust gas
Maximum nominal volume flow rate
Maximum permitted pressure loss
Connector on machine side (external diameter)
Connection pipe provided on site (internal diameter)
Maximum exhaust air/exhaust gas temperature
This tumble dryer is a gas fuel-burning installation without flow safeguarding equipment with a fan behind the heat exchanger (type:
B22). The exhaust air/exhaust gas line must be leak-tight. The gas connection must be carried out according to the national and local
regulations and – depending on the national codes – is subject to approval or acceptance.
As relative humidity inside the exhaust ducting can be as high as 100 %, suitable measures must be taken to prevent a backflow of
condensate into the appliance.
Machine data
Appliance width, total
Appliance height, total
Appliance depth, total
Niche width
Recommended wall spacing (up to the front edge of the machine)
Minimum wall spacing (up to the back edge of the lid)
Packaging width
Packaging height
Packaging depth
Maximum gross volume
Maximum gross weight
Maximum net weight
Max. floor load in operation
Diameter of exhaust duct
Drum diameter
Diameter of drum opening
Drum depth
Drum volume
Diameter of door opening
Maximum door opening angle
54
Standard connection
1N AC 230 V
50 Hz
0,32 kW
1 × 10 A
Model B
1 mm²
339 cm²
310 m³/h
400 Pa
100 mm
100 mm
80 °C
700 mm
1020 mm
763 mm
820 mm
1300 mm
500 mm
760 mm
1215 mm
820 mm
757,2 l
83 kg
75 kg
883 N
100 mm
649 mm
452 mm
550 mm
180 l
452 mm
162°