Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USER MANUAL FOR
III-4) FOLDING
The device must be folded to be transported.
The folding method is similar to the assembly method (unfolding),
but must be carried out in reverse order to the steps illustrated
in the previous chapter:
● Loosen the adjusting screw.
● Press the lowering key on the handset to fold the boom until
the hanger bar ball joint is facing the mast clip.
● Snap the ball joint into the mast.
● Remove the pin and the mast safety shaft.
● Remove the mast safety shaft.
● Lower the mast/boom/hanger bar assembly onto the side rails.
CAUTION: pinching hazard
● Reposition the mast safety shaft in the first hole and put its pin
back.
The device can be vertically transported or stored.
III-5) SEPARATING THE BASE FROM THE
REST OF THE PATIENT LIFT
To easily carry the SAMSOFT 175, you can disassemble it into 2 parts
by unscrewing the knob completely and by removing the safety shaft.
Knob
VOIR DETAIL A
CAUTION: Partially unscrew the adjusting screw
before separating the mast from the wheel base. after
reassembling, check all the fastening elements and the
safety pin are correctly installed. firmly tighten the knob.
SAMSOFT 175
Safety shaft
Pin
Refer to the specifications for the weight of the two separate
elements.
IV - USING THE SAMSOFT 175
IV-1) ELECTRIC SYSTEM OPERATION:
IV-1.1) CONNECTIONS
EN
23
23
Werbung
