Bestway 3D UNDERSEA ADVENTURE Benutzerhandbuch Seite 2

3D UNDERSEA™ ADVENTURE FAMLIY POOL
Owner's Manual
Size: 2.62m x 1.75m x 51cm (8'7" x 69" x 20")
Contents: One pool, two pairs of 3D goggles, one pack of crystals,
repair patch
Please read carefully and keep for future reference.
WARNING
Safety information
Carefully read, understand, and follow all information in the user
manual before installing and using the mini-pool. These warnings,
instructions, and safety guidelines address some common risks of
water recreation, but they cannot cover all risks and dangers in all
cases. Always use caution, common sense, and good judgment when
enjoying any water activity. Retain this information for future use.
Non Swimmers safety
- Continuous, active, and vigilant supervision of weak swimmers and
non-swimmers by a competent adult is required at all times
(remembering that children under five are at the highest risk of
drowning).
- Designate a competent adult to supervise the pool each time it is
being used.
- Weak swimmers or non-swimmers should wear personal protection
equipment when using the mini-pool.
- When the mini-pool is not in use, remove all toys and appealing
objects from the water and the coping to avoid attracting children to
the mini-pool.
- When the mini-pool is not in use, remove all toys or other objects
from its surrounding that could be used by a child as a device to
facilitate the access into the mini-pool (e.g. chairs, big toys, etc.).
Safety devices
- It is recommended to install a barrier (and secure all doors and
windows, where applicable) to prevent unauthorized access to the
mini-pool.
- Personal protective equipment, barriers, pool covers, pool alarms, or
similar safety devices are helpful aids, but they are not substitutes for
continuous and competent adult supervision.
Safety equipment
- Keep a working phone and a list of emergency phone numbers near
the mini-pool.
Safe use of the mini-pool
- Encourage all users especially children to learn how to swim.
- Learn Basic Life Support (Cardiopulmonary Resuscitation - CPR)
and refresh this knowledge regularly. This can make a life-saving
difference in the event of an emergency.
- Instruct all mini-pool users, including children, what to do in case of
an emergency.
- Never dive into any shallow body of water. This can lead to serious
injury or death.
- Do not use the mini-pool when using alcohol or medication that may
impair your ability to safely use the mini-pool.
- When pool covers are used, remove them completely from the water
surface before entering the pool.
- Replace water regularly according to manufacturer
recommendations and depending on hygienic conditions, its
cleanliness, its clarity, and its odour, or if any debris or stains are
present in the mini-pool. Use of chemicals in mini-pools without
water circulation may result in direct contact with the chemicals or in
areas of high chemical concentration resulting in injury to the users.
- If chemicals are occasionally used to reduce the frequency of water
replacement, follow chemicals manufacturer instructions closely
(especially never use more than recommended), ensure the
appropriate mixing of chemicals to avoid possible personal injuries
and store chemicals out of reach of children.
- The use and installation of any electrical appliances around
mini-pools shall be in accordance with the national regulations.
- Where applicable, remove any means of access from the mini-pool
and store it out of reach of children whenever the mini-pool is not in
use.
- Use of accessories not approved by the mini-pool manufacturer (e.g.
ladders, covers, pumps, etc.) may result in risks of injuries or
property damages.
- Use the signage as outlined below.
Keep children under supervision in the aquatic environment.
No diving.
- Please read carefully and follow the safety warnings and safety signs
on the pool wall.
- Selection of appropriate location to prevent the hazard of drowning
of young children, install the mini-pool in a place where it is possible
for the supervision to be constant;
INSTALLATION INSTRUCTIONS
Installation of POOL usually takes only 10 minutes for one person.
1. Find solid, level ground and clear it of debris.
ATTENTION: Do not set up the pool under cables or under trees.
2. Take the pool out of package with care.
3. Spread out the pool and make sure the pool is right side up.
4. Open the safety valves and inflate with an air pump (pump is not
included in this product), close the valves after inflation.
ATTENTION: Do not over inflate.
5. Begin to fill, once pool floor is slightly covered, smooth all wrinkles.
Start at the center of pool and move to the outside.
6. Continue to fill the pool until the water capacity reaches 75%.
Please kindly pay the utmost attention not to overfill the pool for
security reasons.
WARNING: Do not leave pool unattended while filling with water.
DISASSEMBLY AND CLEANING
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Drain the pool.
ATTENTION: Do not leave the drained pool outside.
3. Open the safety valve and squeeze the valve at its base to deflate.
4. After deflation, use a damp cloth to clean.
MAINTENANCE
WARNING: If you do not adhere to the maintenance guidelines
covered herein, your health might be at risk, especially that of your
children.
1. Replace the pool water regularly; unclean water is harmful to user's
health.
2. Please contact your local retailer to obtain chemicals to treat the
water in your pool. Be sure to follow the chemical manufacture's
instructions.
3. Proper maintenance can maximize life of your pool.
4. See packaging for water capacity.
REPAIR
If a chamber is damaged, use the provided repair patch.
1. Completely deflate the product.
2. Clean and dry the damaged area.
3. Apply the provided repair patch and smooth out any air bubbles.
STORAGE
1. Make sure all water is drained from the pool. Once pool is
completely dry, put the folded pool into the package.
2. Store in a cool, dry place and out of children's reach.
3. We strongly recommend the pool is disassembled during the off
season (winter months).
Instructions For 3D Goggles
WARNING: USE ONLY UNDER COMPETENT SUPERVISION.
WILL NOT PROTECT AGAINST DROWNING. AGE: OVER 3
ADJUSTING THE HEAD STRAP
• The head strap is used to hold the goggles in place; Tighter is not
necessarily better as this may cause discomfort and marking around
the eyes.
• Correct adjustment can be obtained by tensioning the band until a
comfortable fit is achieved.
ADJUSTING THE BRIDGE STRAP
• Suitable bridge strap is essential for both comfort and a watertight
seal.
• Check the provided bridge straps, use the bridge strap with suitable
size only.
NOTE: "S" for small size, "M" for medium size, "L" for large size.
FITTING THE GOGGLES
• To clear water or to adjust goggles, take a firm grip on the eye cup
and tilt the lower edge of the eye cup slightly away from the face.
REMOVING THE GOGGLES
• To remove goggles, put thumbs under head strap at side of the
head. Slide thumbs to the back of the head and lift elastic from back
to front of the head.
EYE SAFETY WARNING
WARNING: Never pull eyecups away from face as they may spring
back and cause injury. Do NOT dive into the water wearing goggles.
For surface use only.
• It is recommended that teachers, coaches or mature swimmers
demonstrate the methods of adjusting, fitting and removing goggles.
CLEANING AND STORAGE
• Rinse the goggles with clean water but never use detergents or
alcohol etc. as cleaning agents.
• Avoid unnecessary exposure to sunlight and air.
• Avoid contact with oils and greases. Some sun creams and lotions
are of an oily composition.
• Avoid exposure to heat and contact with hot surfaces.
• Store in a cool, dry place in a box or bag and in the dark, and do not
distort during storage.
2
YEARS