Silvercrest SFW 350 E5 Bedienungsanleitung Seite 10

6) Place your selected cutting disc 0 into the meat grinder casing 6 so that
the fixings on the cutting disc 0 are located in the openings in the meat
grinder casing 6 .
7) After everything has been correctly assembled, screw the ring clamp q
back on hand-tight .
8) The ready-assembled meat grinder casing 6 is connected by a bayonet
connector to the motor unit 5:
– Fit the meat grinder casing 6 into the motor unit 5 so that the
symbol on the meat grinder casing 6 is aligned with the
the motor unit 5 . The locking button t pushes in (fig . B) .
– Press the meat grinder casing 6 in gently, at the same time turning the
feed tube on the meat grinder casing 6 to the middle position (fig . B),
so that the
the meat grinder casing 6 clicks into place, the locking button t pops
out again .
– Finally, place the feeding tray 3 on top of the feeding funnel .
– To dismantle it, press the locking button t and turn the feeding funnel to
the right (Fig . B)
Assembling the sausage stuffer attachment
Unfold the fold-out side - there you will find the step-by-step illustrations for
assembling the appliance .
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder" .
2) Dismantle all parts which are fitted to/in the meat grinder casing 6 and
clean them .
3) Coat all metal parts with cooking oil .
4) Put the transport screw 7, the spring 8 and the cross blade 9 back into
the meat grinder casing 6 .
5) Insert the sausage disc e so that the fixings on the sausage disc e are
located in the openings in the meat grinder casing 6 .
6) Then place the sausage stuffer attachment w before the sausage disc e .
7) Screw the ring clamp q on hand-tight .
8) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder" .
SFW 350 E5
symbol on the feed tube points to the
. You can now pull the meat grinder casing 6 out .
symbol on
symbol . When
GB │ IE │ NI │ CY │ 7 ■