Setting The Time Of Day; The Timer Function - Respekta CH 99040 60 Bedienungsanleitung

1. Press and hold the timer sensor, until the first two digits of the display start to flash.
2. Release the timer sensor, then use the Add/ON sensor and Dec/OFF sensor to set
the hour time.
3. Press the timer sensor again and the last two digits of the display will start to flash.
4. Use the Add/ON sensor and Dec/OFF sensor to set the minute time.
5. When the time of day is shown on the display correctly, press the timer sensor again
to confirm the setting.
 You can use the timer sensor to set a particular period of time. After this time the
appliance will stop operating.
 You can choose one of the settings below.
No. of touches
 Once you have set a countdown period, the appliance will start to countdown. The
display shows the time remaining until the appliance stops operating.
 When the countdown time has been reached, 00:00 will appear and the appliance will
stop running.
 Third touch: the appliance runs in the highest setting.
 Each touch decreases the setting by factor 1.
 If the appliance is running in the lowest setting, another
touch switches it off.
 Touch to switch the light on or off.
 You can switch on the light even the appliance is not
running.
 Displays the setting the appliance is running in.
 Touch to start the timer function.

Setting the time of day

The timer function

1
2
3
4
Countdown period
5 minutes
15 minutes
30 minutes
Cancel timer function
54