Respekta CH 99040 60 Bedienungsanleitung Seite 61

4. Remove the grease filters and push out the illuminant. Be especially careful
while doing so.
5. Pull the illuminant carefully out of the hole and
disconnect the energy supply wire.
6. Now connect the new illuminant to the energy
supply wire.
7. Push the wires back into the hole and fix the new
illuminant.
Do not touch the illuminant with your hands. The sweat on your fingers will reduce the
operating time of your new illuminant. Use a thin cloth or a thin glove.
1. Disconnect the appliance from the energy supply.
2. The Illuminant should have cooled down before you remove it.
3. Remove the old illuminant.
4. Replace it with a new one of the same kind and power.
The illuminants as well as all kinds of filters do not carry a
The power cord must be replaced by a qualified and authorized professional only.
figures similar
Changing the illuminant -Halogen
Attention!
guarantee!
Replacing of the power cord
DANGER!
61