Installation; Unpacking And Positioning; General Information - Respekta CH 99040 60 Bedienungsanleitung

1. Remove the plug out of the socket.
2. Cut off the power cord directly at the appliance.
 This appliance is not intended to be run by persons (including children) with reduced
physical, sensory and mental capabilities or lack of experience or knowledge, unless
they are supervised or instructed concerning the use of the appliance by a person
who is responsible for their safety. Children must be supervised to ensure that they do
not play with the appliance.
While unpacking, the packaging materials (polythene bags, polystyrene
pieces, etc.) should be kept away from children.
1. Unpack the appliance carefully. Dispose of the packaging as described in the chapter
waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3. Check before installation if the power cord or the appliance itself are not damaged.
4. The appliance must be connected to the mains with a properly grounded socket only.
5. Do not install the appliance in an area where it may come in contact with water or rain
in order that the insulation of the electrical components would not be damaged.
6. The appliance is designed for indoor use only.
7. The appliance must be correctly connected to the mains.
Strictly observe the minimum distance between hood and hob.
Minimum distance hood to
Glass-ceramic and cooking ring
Gas jet
Coal / oil / stove wood firing
1. Strictly observe the consecutive numbering of the installation steps and the
additional instructions.
2. Models which lead the exhaust outwards: the exhaust is conducted by an exhaust
hose which is connected with a connecting ring.
3. The diameter of the exhaust hose has to meet the diameter of the connecting
ring.
WARNING!

5. INSTALLATION

Unpacking and positioning

General information

43
65 cm
70 cm
85 cm