Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Installation conditions
The installation of the equipment may only be car-
ried out by the public water supply company or by an
installation company listed in the installer directory
of a water supply company.
Observe the local installation regulations, general
guidelines, general hygiene regulations and the
technical specifications.
The sewage system (discharge) must be min.
DN 50. The waste water connection of the filter
is DN 50.
Attention: The installation site must be protected
against frost and must ensure the pro-
tection of the filter against e.g. solvent
vapours, fuel oil, lees, chemicals of any
kind, UV radiation and heat sources
above 40 °C.
Attention: Keep the plastic parts free from grease,
solvents and acidic as well as basic
detergents. The plastic parts must be
replaced even if there is no visible
damage after severe concussions and
shocks e.g. due to the use of unsuitable
tools or if dropped on stone floors etc
(danger of bursting). Avoid extreme
pressure impact.
EN
29
Werbung
