Motorola PMLN6521 Installationsanleitung Seite 7

OPERATING SPECIFICATIONS
Vehicular Power Adaptor (NNTN8040)
Input voltage range: 10.8 to 33 VDC
Vehicular Power Module (PMLN7017)
Input voltage range: 10.8 to 16.6 VDC
SAFETY AND GENERAL INFORMATION
A properly installed Vehicular Charger/Holder Kit minimizes service
calls. When mounting the components of the Vehicular Charger/
Holder Kit, consider the following factors:
• The mounting surface must have sufficient strength to support
the item being mounted to prevent it from becoming loose over
time.
• DO NOT attach components to any part of the vehicle that is
subject to excessive vibration.
• The proposed location of the item being mounted or wires/cables
attached must not interfere with driver/passenger seating or leg
space.
• Use the supplied mounting hardware.
• Ensure that the cables are not stretched, and not subject to heat
from the engine, transmission housing or heating ducts.
• Crimp connectors securely.
• DO NOT run cables over sharp edges that may cause excessive
wear or chaffing of the cable insulation.
• DO NOT install components in locations where they may cause
interference to the operation of the vehicle's controls.
Check the required mounting locations. Modern cars are equipped
with power supply connections for mobile phone inside the
passengers cabin. It is preferable to connect the power cable to
these connections.
On some vehicles, it is necessary to penetrate the bulkhead to reach
the battery. Ensure that there is cable clearance on the opposite side
of the bulkhead and that vehicle's Electronic Control Modules
(ECM's) are not installed on the opposite side of the bulkhead before
drilling commences. Protect the cable where it passes through the
bulkhead by using a grommet or similar protective measures.
5