Motorola PMLN6521 Installationsanleitung Seite 11

Jack Screw
(x2)
Figure 5. Installing the Vehicular Power Module onto the cradle.
When installing the PMLN6434 & PMLN6431 Vehicular Charging
Cradle with Vehicular Power Module Kit, use the following procedure.
See Figure 5 above:
1. Secure the Vehicular Power Module onto the bottom of the
cradle pocket by screwing the jack screw onto the insert nut.
Note: DO NOT connect the power cable to the cradle until the
power cable is fully installed.
Insert Nut
(x2)
Vehicular Power Module
(PMLN7017)
9