Motorola PMLN6521 Installationsanleitung Seite 14

5. For ignition installation, perform the following steps:
a. Cut the long blue lead to the desired length, strip the edge
and crimp a terminal lug (not included) to the lead. Verify that
the fuse is at a distance of 20 to 30 cm away from the
connection point. It is not good practice to connect the leads
to the battery pillars; use the closest battery connection
provided. The Vehicular Charger Kit could be damaged if
there was a malfunction in the vehicle's electrical system.
b. Connect the blue lead to the ignition switch. Verify that the
voltage is high with ignition on, during cranking and while
vehicle is running. When ignition is off, the voltage is low.
6. Connect the RF cable into the FME cable connector (see
Figure 8 and "Antenna Kit Installation" on page 13). Applicable to
PMLN6522, PMLN6433 & PMLN6431 for Vehicular Charging RF
Cradle.
Figure 8. PMLN6522, PMLN6433 & PMLN6431 Vehicular Charger
Connect to FME cable connector
RF Connection
12