Waste Disposal - Meec tools 025258 Bedienungsanleitung

EN
• Empty the chain oil tank if the saw is not
going to be used for some time.
• Put the bar guard on the bar.
• Never allow brake fluid, petrol, oil-based
products, penetrating oils, etc. to come
into contact with plastic parts.
• Store the chain saw away from corrosive
substances, such as salt and fertiliser.
TROUBLESHOOTING
Problem
The chain
saw does not
work.
The chain saw
does not work
continuously.
The chain is
dry.
The chain/bar
is hot.
The chain saw
jerks, vibrates
or does not
saw properly.
62
Possible cause
Discharged battery.
The battery is not correctly
inserted.
Loose connection (external).
Loose connection (internal).
The power switch is faulty.
No oil in the tank.
The ventilation hole in the oil
filler cap is clogged.
The oil outlet is blocked.
No oil in the tank.
The ventilation hole in the oil
filler cap is clogged.
The oil outlet is blocked.
The chain is blunt.
The chain is overtensioned.
The chain is too loose.
The chain is blunt.
The chain is worn.
The chain is fitted in the wrong
direction of rotation.

WASTE DISPOSAL

Recycle used batteries in accordance with local
regulations.
Marking: Cd = cadmium, Hg = mercury, Pb =
lead
NOTE:
Remove the battery from the saw before
waste disposal.
Step
Charge the battery.
Remove the battery and fit it correctly.
Take the chain saw to an authorised service
centre to be checked and repaired.
Fill up with oil.
Clean the cap.
Clear the oil outlet.
Fill up with oil.
Clean the cap.
Clear the oil outlet.
File or replace the chain.
Adjust the tension of the chain.
Adjust the tension of the chain.
File or replace the chain.
Replace the chain.
Remove the chain and fit in the right direction
of rotation.