INVENTOR DR2VI32-09WFI Benutzer- & Installationshandbuch Seite 17

Safety Precautions
●Have the unit professionally installed.
Improper installation by an unqualified person may result in water
leak, electric shock, or fire.
●Place the unit on a stable, level surface that withstands the
weight of the unit to prevent the unit from tipping over or falling
causing injury as a result.
●Only use specified cables for wiring. Securely connect each
cable, and make sure that the cables are not straining the
terminals.
Cables not connected securely and properly may generate heat
and cause fire.
●Take necessary safety measures against typhoons and
earthquakes to prevent the unit from falling over.
●Do not make any changes or modifications to the unit. In case
of problems, consult the dealer.
If repairs are not made properly, the unit may leak water and
present a risk of electric shock, or it may produce smoke or cause
fire.
●Do not touch the fins on the heat exchanger with bare hands.for
they are sharp and dangerous.
●In the event of a refrigerant gas leak, provide adequate
ventilation to the room.
If leaked refrigerant gas is exposed to a heat source, noxious
gases, fire or explosion will be caused.
●Do not try to defeat the safety features of the devices, and do
not change the settings.
Defeating the safety features on the unit such as the pressure
switch and temperature switch or using parts other than the
dealer or specialist may result in fire or explosion.
WARNING
●Be sure to carefully follow each step in this handbook when
installing the unit.
Improper installation may result in water leak, electric shock, fire
or explosion.
●Have all electrical work performed by a licensed electrician
according to the local regulations and the instructions given in
this manual. Secure a circuit designated exclusively to the unit.
Improper installation or a lack of circuit capacity may cause
the unit to malfunction or present a risk of electric shock.fire or
explosion.
●Securely attach the terminal cover(panel) on the unit.
If installed improperly, dust and/or water may enter the unit and
present a risk of electric shock, smoke or fire.
●Only use refrigerant R32 as indicated on the unit when installing
or relocating the unit.
The use of any other refrigerant or an introduction of air into
the unit circuit may cause the unit to run an abnormal cycle and
abnormal cycle and cause the unit to burst.
WARNING
●When installing the unit in a small room, safeguard against
hypoxia that results from leaked refrigerant reaching the threshold
level.
Consult the dealer for necessary measures to take.
●When relocating the air conditioner, consult the dealer or a
specialist.
Improper installation may result in water leak, electric shock, fire
or explosion.
●After completing the service work, check for a refrigerant gas
leak.
If leaked gas refrigerant is exposed to a heat source such as fan
heater,stove,and electric grill, noxious gases , fire or explosion.
●Only use specified parts.
Have the unit professionally installed. Improper installation may
cause water leak, electric shock,smoke,fire,explosion.
15 15