Ryobi RY36LM40A Bedienungsanleitung Seite 8

INTERFACE BOARD OVERVIEW
The interface board displays the status and
condition of the product.
1
9
8
7
6
1. High load - indicates that the load is
too high for the current setting and the
product might stall. Switch to power mode,
increase cutting height, or reduce walking
speed.
2. Blade check indicator - indicates that the
blade must be checked. Replace the dull
blade to keep the product in good working
condition.
3. Battery charge status button - powers up
the battery level indicator when pressed.
4. Battery level indicator - indicates the
amount of charge left in the battery packs.
● If only one LED lights up, the battery
pack capacity is lower than 25%.
● If two LEDs light up, the battery pack
capacity is between 25% and 50%.
● If three LEDs light up, the battery pack
capacity is between 50% and 75%.
● If four LEDs light up, the battery pack is
fully charged. The battery pack capacity
is between 75% and 100%.
5. Overload indicator - indicates that the
product is overloaded and that the blade
may be jammed.
6. Mode button - changes the cutting mode
of the product when pressed.
7. Power mode - indicates that the blade is at
high speed for heavy grass cutting.
8. Smart mode - indicates that the mower is
able to adjust the blade speed depending
on the load on the product for general
cutting.
9. Eco mode - indicates that the blade is at
low speed for thin grass cutting.
8
Original Instructions
2 3
5 4