Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Changing the oil should take place when the engine is warm.
WARNING! Drain fuel before replacing the oil.
Only use engine oil (15W-40).
•
Always set up the device on a level and stable surface. Do not operate the generator on forest
soil, which radiates heat during operation and in the cooling phase and can ignite flammable
materials!
•
Remove the screws and the cover (5).
•
Open the oil filler cap (17) and drain the warm engine oil into a container by tilting the generator.
•
Pour in engine oil (approx. 0.28 litres).
•
Close the cover (5) and tighten the screws.
Low oil switch off
The low oil switch-off responds, if there is not enough engine oil. The oil check bulb (12) starts to
flash when there is insufficient oil in the motor. The check bulb begins to flash when the oil amount
has gone below the safe level. The engine will turn off independently after a short time. Restart is
possible only after pouring in more engine oil.
10. Storage
Preparation for storage
•
Empty the petrol tank with a petrol suction pump. Remove fuel filter and drain the carburettor.Loosen the
screw on the lower side of the carburettor and drain the petrol into a receptacle provided for this purpose..
Warning notice: Do not remove fuel in closed rooms, close to fire or whilst smoking. Vapours
can cause explosions or fires.
•
Start the engine and leave it running until the rest of the petrol has been used up.
•
Store fuel in tanks specifically designed for this purpose.
•
Change the oil after each season. To do this, remove the old oil from the warm engine and refill
with new oil.
•
Remove the spark plug. Fill about 20 ml of oil into the cylinder using an oil can.
•
Slowly pull the express start so that the oil protects the cylinder from the inside.
•
Screw the spark plug back in
•
Store the device in a well ventilated place or area.
11. Transport
Preparation for transporting
•
Empty the petrol tank with a petrol suction pump or alternatively using the petrol tap and a suit-
able canister.
•
Once it is ready for use, leave the engine running until the rest of the petrol has been used up.
•
Empty the engine oil from the engine (as described).
•
Remove the spark plug connector (16) from the spark plug.
•
Secure the device with a tension belt to prevent it slipping out of place.
•
The generator can be lifted and carried by using the handle.
32 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Werbung
