Replacing Of The Illuminant - Pkm KG 230.4 A++ INOX DESIGN Bedienungsanleitung

Cooling compartment
1. The cooling compartment is equipped with an automatic defrost-system.
2. The water is drained at the back inside the appliance.
3. The water is collected in a container underneath the compressor. The water
evaporates in this container
4. The drain must not be blocked.
5. Clean the drain carefully with a pipe cleaner.
Freezing compartment
1. Remove the contents from the freezing-compartment and put them into a
cooling box.
2. Place a container in front of the appliance to catch the water.
3. Switch off the appliance by turning the thermostat to position 0/AUS/OFF and
disconnect it from the mains.
4. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
5. Remove the big pieces of ice first.
6. Afterwards remove the small pieces of ice.
7. Wipe and dry the appliance and door seals with dry and soft cloths.
8. After cleaning leave the door open for some time to ventilate the appliance.

5.2 Replacing of the illuminant

Important information: The replacing of the illuminant should be carried
out by a qualified professional only
intended for persons who are inexperienced in such a work.
WARNING! Set the thermostat to 0 and disconnect the appliance
1.
from the mains, before you change the illuminant. RISK OF
ELECTRIC SHOCK!
2. Remove the illuminant cover. Push it up and out.
3. Remove the controller box.
4. Hold the cover with one hand and pull with the other one while pressing the
connector latch.
5. Replace the illuminant by a new one of the same kind and power. The
illuminant must snap into place properly.
8 Not covered by guarantee!
8 ! The following instructions are not
40