First Aid; Packaging; Ec Declaration Of Conformity - Makita DBC260U Betriebsanleitung

Never straighten or weld damaged cutting tools.
– Operate the Brush Cutter/String Trimmer with as little noise and contamination
as possible. In particular, check that the carburetor is set correctly.
– Clean the Brush Cutter/String Trimmer at regular intervals and check that all
screws and nuts are well tightened.
– Never service or store the Brush Cutter/String Trimmer in the vicinity of naked
flames.
– Always store the Brush Cutter/String Trimmer in locked rooms and with an
emptied fuel tank.
Observe the relevant accident prevention instructions issued by the relevant
trade associations and insurance companies.
Do not perform any modifications on the Brush Cutter/String Trimmer, as doing
so will endanger your safety.
The performance of maintenance or repair work by the user is limited to those
activities described in the instruction manual. All other work is to be done by an
Authorized Service Agent. Use only genuine spare parts and accessories
released and supplied by MAKITA.
Using non-approved accessories and tools will cause an increased risk of
accidents.
MAKITA will not accept any liability for accidents or damage caused by the use
of non-approved cutting tools, fixing devices of cutting tools, or accessories.

First Aid

In case of accident, make sure that a first-aid box is available in the vicinity of the
cutting operations. Immediately replace any item taken from the first aid box.
When asking for help, please give the following information:
– Place of the accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name

Packaging

The MAKITA Brush Cutter/String Trimmer is delivered in two protective
cardboard boxes to prevent transport damage. Cardboard is a basic raw material
and is therefore reusable or suitable for recycling (waste paper recycling).
Model; DBC260U, DBC260L
We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, ISO11806,
EN55012 in accordance with Council Directives, 89/392/EEC, amended 98/37/EEC, 93/68/EEC, 89/336/EEC, amended 92/31/EEC.
Measured Sound Power: 111.7 dB
Guarantee Sound Power: 114 dB
These sound power levels were measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8,Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton kyenes, Bucks MK15 8JD, ENGLAND
EC-DECLARATION OF CONFORMITY
CE2008
Tomoyasu Kato
Director
7