Albrecht DB 275 Dualband Bedienungsanleitung Seite 80

4.7 Cloning a ready programmed radio (Master) via wired connection to a another radio
(Slave)
Please note that you will need a special optional available cloning cable!
a) Switch the Master radio on while pressing PTT and MONI buttons together..
ζowΝδστΝshowsΝ"ΝCLONE READY "Νέέ
b) Connect the Master with the Slave radio by transfer cable and turn on the power of the
Slave radio
c) Press MONI
the Slave radio green.
After about 30 seconds cloning is completed. Master radio turns back into "ΝReady
d)
cloning"Νand is able to clone the another or more Slave radio(s) if needed).
e) The Slave radio shows CLONE and resets automatically to normal operation.
In case of an error during cloning the radio will show CLONE ERROR. Please check the cable
connections and repeat the procedure.

If you need to clone more than only 1 radio, please turn off the cloned radio (the

Slave)

Take off the cable from the Slave radio and connect the next Slave radio

Repeat the steps c) ..d)
To quit the procedure, turn the radio off and on again
on the Master radio. At the Master, the LED begins to flash red and at