Installation; Unpacking And Positioning; Instructions For The Installer - Pkm GKM 4.1 Bedienungsanleitung

2. Installation

DANGER!
CONNECTED TO THE GAS SUPPLY BY A QUALIFIED PROFESSIONAL
ONLY, WHO KNOWS AND FOLLOWS CAREFULLY ALL LEGAL
REGULATIONS AND THE ADDITIONAL REGULATIONS GIVEN BY
THE LOCAL GAS SUPPLIER.

2.1 Unpacking and positioning

1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3. Check that the appliance and the power cord are not visible damaged.
4. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
5. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.

2.2 Instructions for the installer

The following instructions are intended for a qualified professional so they can
carry out the installation, adjustment and service relevant to the current regulations.
Modifications relevant for the operating mode (incl. disconnecting) of the appliance
must be carried out with great care.
The manufacturer is not liable for any damage caused by an installation
which does not meet the current local and legal regulations.
Only install and operate the appliance in permanently-ventilated rooms. The room
must be well-ventilated; otherwise the appliance does not operate properly. The
inflowing air must come through openings of the outer walls. The openings must
not be blocked at any time (outside as well as inside). Installation and maintenance
must be carried out by a qualified professional only relevant to the current local and
legal regulations.
THE APPLIANCE MUST BE INSTALLED AND
25