Changing Of The Hinge Position - Pkm KS 115.4 A++T Bedienungsanleitung

Levelling
1. Use the adjustable feet at the front to level the appliance properly.
2. When the appliance is not levelled, the door and the magnetic seals will not
close properly.

3.2 Changing of the hinge position

WARNING! Switch off and unplug the appliance before changing the
hinge position. RISK OF ELECTRIC SHOCK!
CAUTION! The change of the hinge position must be carried out by
at least two persons; otherwise you may hurt yourself or damage the
appliance. Do not tilt the appliance more than 45
NOTICE! Empty the appliance before. Set the adjustable feet to their
highest position.
1. Remove the two cover caps on the worktop carefully using a small pointed
object and unscrew the two worktop-screws (fig. 1). Then unscrew the screws
on the back. Remove the worktop and the top hinge bracket (fig. 2).
2. Open the door slightly and remove it from the bottom hinge.
3. Tilt the appliance slightly backwards. A second person should hold the
appliance now, so you have access to the bottom hinge.
4. Remove the two screws of the bottom hinge. Remove the adjustable foot on the
left and fix it on the opposite side (fig. 3).
5. Fix the bottom hinge on the opposite side.
6. Remove the sealing plug from the top left opening of the door und press it
firmly into the top right one.
7. Place the worktop upside down. Remove the hinge bracket (with axis, fig. 2) and
fix it on the opposite side. Do not tighten the screws too firmly.
8. Reinstall the door. Check, that the hinge axis meets its proper position in the
bottom left opening of the door.
9. Place the worktop on the appliance with the door closed. Check, that the top
axis meets the top opening (where the seal plug was). Fasten the two top screws
first and then the screws on the back slightly. Adjust the worktop properly.
Check, that the door is adjusted perpendicularly.
10. Now tighten all 4 screws of the worktop. Do not tighten the screws too firmly.
0
.
27