Installation; Site; Changing Of The Hinge Position - Pkm KS 104.4 A-UB Bedienungsanleitung

3. Installation

3.1 Site

1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. The doors must open completely and without hindrance.
8. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
9. Connect the appliance to the mains properly.
10. The nameplate is inside the appliance or at the back.

3.2 Changing of the hinge position

WARNING! Switch off and unplug the appliance before changing the
hinge position. RISK OF ELECTRIC SHOCK!
CAUTION! The change of the hinge position must be carried out by
at least two persons; otherwise you may hurt yourself or damage the
appliance. Do not tilt the appliance more than 45
1. Remove the screws (1) and then the top metal-panel (6). Now remove the door.
Put the door on a soft surface to avoid scratches. A second person should assist
you.
2. Unscrew the top hinge axis (5) from the top panel. Now screw the axis to the
left side of the cover panel (6).
3. To remove the bottom hinge (2) remove the two screws (8).
4. Now unscrew the left front foot (4) and fix it on the opposite right side.
5. Move the complete bottom hinge (2) together with the other hinge axis (7) to
the opposite left side and fix it with the two screws (8). Also install the other
front foot.
6. Place the door carefully on the hinge axis (7) of the bottom hinge. Keep the
door properly adjusted. A second person should assist you.
7. Place the hinge axis (5) of the top metal-panel (6) into the corresponding device
0
.
25