FAR KJ 45 Bedienungsanleitung Seite 18

ADJUSTMENT OF THE COUPLE TIE ROD/HEAD (fi g. f14-f15-f16)
Changing the length of the insert to clamp, the position of the head (B)
compared to the threaded tie rod (A) should be adjusted.
Disconnect the riveting tool from the compressed-air supply.
Screw an insert of the desired length on the threaded tie rod manually until the
insert head touches the riveting tool head (B). The head is adjusted correctly
if the threaded tie rod comes out of the insert screwed on it of about 2 mm.
Otherwise unblock the ring nut (C) with a 22 mm standard spanner then screw
or unscrew the head (B) up to the right position, and block the ring nut (C).
ATTENTION!
Disconnect the machine before carrying out the above-
mentioned operations.
A
~2mm
B
18
C
f14
Date 04-2015
GB
f15
C
22 mm
f16
KJ 45
B
Revisione - 05