Guarantee And Technical Assistance; Safety Measures And Requirements - FAR KJ 45 Bedienungsanleitung

INSTRUCTIONS FOR USE I
INDEX

GUARANTEE AND TECHNICAL ASSISTANCE .................................. 12

SAFETY MEASURES AND REQUIREMENTS ................................... 12

TOOL IDENTIFICATION ........................................................... 13
GENERAL NOTES AND USE ...................................................... 13
MAIN COMPONENTS ............................................................. 13
TECHNICAL DATA ................................................................. 13
AIR FEED ........................................................................... 14
PRELIMINARY OPERATIONS .................................................... 14
PLACING OF THE INSERT ........................................................ 15
WORKING PROBLEMS ........................................................... 16
CHANGE OF SIZE .................................................................. 17
ADJUSTMENT OF THE COUPLE TIE ROD/HEAD ............................... 18
TOOPING UP THE OIL-DYNAMIC CIRCUIT ..................................... 19
MAINTENANCE .................................................................... 19
DISPOSAL OF THE RIVETING TOOL ............................................ 19
GUARANTEE AND TECHNICAL ASSISTANCE
FAR riveting tools are covered by a 12-months guarantee. The period
of guarantee starts from the date of delivery specifi ed on the invoice or
delivery note.
The guarantee covers the user/buyer when the tool is bought through an
authorized dealer and only when it is employed for the uses it was conceived
for. The guarantee is not valid if the tool is not used or maintained as indicated
in the instruction and maintenance handbook.
In case of defects or faults FAR S.r.l. undertakes only to repair and/or replace
the components it considers faulty.
SAFETY MEASURES AND REQUIREMENTS
CAUTION!!!
All the operations must be done in conformity with the
safety requirements, in order to avoid any consequence
for your and other people security and to allow the best
tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact FAR s.r.l.
authorized service centers and use only original spare parts. FAR
s.r.l. may not be held liable for damages from defective parts
caused by failure to observe what mentioned above (EEC directive
85/374).
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when using the tool.
• Use equipment recommended in the maintenance chapter to do any
maintenance and/or regulation of the tool.
• For topping up the oil, we suggest using only fl uids in accordance with the
features specifi ed in this working book.
• If any drop of oil touches your skin, you must wash with water and alkaline
soap.
• The tool can be carried and we suggest putting it into its box after using.
12
GB
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the tool is not fed.
• A safety balancer is suggested when it is possible.
• The tool is made so that acoustic pressure level continuous equivalent weighted
A is not more than 74 dB (A) where people works.
• If the noise level is more than 85 dB (A), you must use some hearing protections
(anti-noise headset, etc.).
• The workbench and the work surface must be always clean and tidy. The untidy
can cause damages to people.
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have the correct size to
be used.
• Do not carry the connected tool by pulling the hose. The hole must be far from
any heating sources or from cutting parts.
• Keep the tools in good conditions; do not remove either safety parts or
silencers.
• After repairing and/or adjusting, make sure you have already removed the
adjusting spanners.
• Before disconnecting the compressed air hose from the tool make sure that
there is no pressure in the hose.
• These instructions must be carefully followed.
ATTENTION! In case of strong impacts or accidental falls the
machine should be completely overhauled.
Date 04-2015
KJ 45
Revisione - 05