Tool Identification; Main Components; Technical Data - FAR KJ 45 Bedienungsanleitung

KJ 45

TOOL IDENTIFICATION

The riveting tool KJ45 is identifi ed by a label showing the name and the
address of the manufacturer and the model also. If any service is requested
please make reference to the data shown on the label.
Name and address of
manufacturer
GENERAL NOTES AND USE
The tool can be employed only for threaded inserts M4÷M12.
The KJ45 hydropneumatic system assures more power than the pneumatic
system used for other models. That means a reduction in the problems due
to the wear and tear of the components, therefore, there will be an increase
in reliability. The technical solutions adopted reduce the dimensions and the
weight of the tool, which is very handy for these reasons. The possibilities
of leakage from the oil-dynamic system, are eliminated by some sealed
gaskets, which solve this problem.
Revisione - 05
GB

MAIN COMPONENTS

A) ................................................................... Threaded tie rod
B) ................................................................................. Head
C) .......................................................... Ring-nut clamping head
D) ............................................................... Control push-button
E) ...................................................... Compressed air connection
F) ............................................................ Pressure control valve
G) ..................................................................Protection bottom
H) .................................................................. Pneumatic motor
I) .........................................................................Oil tank plug
L) .............................................................. Balancer connection
M) ............................................................Stroke-adjusting knob
N) .................................................................... Stroke indicator
O) ................................................................ Tube carrying head
P) ............................................................Forced unscrewing rod
*
with M10 tie rod
Ø 27
Model
A B C D
312

TECHNICAL DATA

• Working pressure ...................................................... 6 - 7 BAR
• Min. int. diam. of the compressed air
feeding hose ......................................................ø min. = 8 mm
• Max free air consumption per cycle ..................................... 11 NI
• Force (6 BAR)............................................................... 28 KN
• Noise level .............................................................< 74 db(A)
• Weight (with equipment for M10) ...................................... 2.9 Kg
• Working temperature .................................................. -5°/+50°
• Root mean square in total acceleration
frequency (Ac) to which
the arms are subjected ...........................................< 2.5 m/sec2
Date 04-2015
296*
O L I H N
124*
F
E
G
Ø 130
Ø 50
P
M
13