Before First Use; Installing The Water Filter - Sage the Oracle SES980 Kurzanleitung

Functions

BEFORE FIRST USE

Machine Preparation
Remove and discard all labels and packaging
materials attached to your espresso machine.
Ensure you have removed all parts and
accessories before discarding the packaging.
Clean parts and accessories (water tank,
portafilter, filter basket, jug) using warm water
and a gentle dish washing liquid. Rinse well
then dry thoroughly.
TIP
To easily manoeuvre your machine, use the drop
down swivel foot located under the drip tray.

INSTALLING THE WATER FILTER

• Remove the water filter and water filter
holder from the plastic bag.
• Soak the filter in cold water for 5 minutes.
• Wash the filter holder with cold water.
• Set the reminder for next month
of replacement. We recommend
to replace the filter after 3 months.
• Insert the filter into the two parts of the
filter holder.
• To install the assembled filter holder into
the water tank, align the base of the filter
holder with the adapter inside the water tank.
Push down to lock into place.
• Fill the water tank with cold water before sliding
back into position at the back of the machine
and locking into place.
FIRST USE
1. Ensure tank is filled with cold water.
2. Press POWER button to turn machine on.
3. The main LCD will display 'Hrd3', prompting
you to set the water hardness level.
Setting Water Hardness
• Dip the test strip into a sample of the water
you have filled the tank with. Wait for one
minute. The water hardness setting is
indicated by the number of red squares
displayed on the test strip.
• Rotate SELECT dial to the required
setting from 'Hrd1' (softest water) to 'Hrd5'
(hardest water). Press SELECT dial to set.
4. After approximately 5 minutes, the machine
will reach the default operating temperature
93˚C and all 6 buttons will illuminate.
The machine is now in STANDBY mode.
POWER SELECT
|
TEMP TEXTURE
HOT WATER LONG BLACK
EN
9