Sage the Oracle SES980 Kurzanleitung Seite 27

PROBLEM
Water does not flow
from the group head
FILL TANK on LCD
but water tank is full
No steam
or hot water
No hot water
No steam
The machine is
'On' but ceases to
operate
Steam pouring out of
group head
Espresso only drips
from the portafilter
spouts, restricted
flow
Espresso flows out
too quickly
POSSIBLE CAUSE
• Machine has not reached
operating temperature.
• Water tank is empty.
• Water tank not fully
inserted and locked.
• Water tank not fully
inserted and locked.
• Machine is not turned
on or up to operating
temperature.
• Water tank is empty.
• Steam wand is blocked.
• Coffee is ground
too finely.
• The coffee is ground
too coarsely.
• Coffee beans are stale.
WHAT TO DO
• Allow time for the machine to reach
operating temperature. The POWER
button will stop flashing when machine
is ready.
• Fill tank. Prime the system by:
• 1) Pressing 2 CUP button to run water
through
the group head for
30 seconds.
• 2) Pressing HOT WATER button to run
water through the hot water outlet for
30 seconds.
• Push water tank in fully and lock latch
closed.
• Push water tank in fully and lock latch
closed.
• Ensure the machine is plugged in and
the POWER button is illuminated but not
flashing.
• Fill water tank.
• Refer to 'Cleaning the Steam Wand',
page 21.
• Turn machine off. Wait for
60 minutes and turn machine back on.
• If problem persists, call Sage
Customer Service Centre.
• Turn machine off. Wait for
60 minutes and turn machine back on.
• If problem persists, call Sage
Customer Service Centre.
• Adjust the grind size to a higher number
to make the grind size slightly coarser.
• Adjust the grind size to a lower number
to make the grind size slightly finer.
• Use freshly roasted coffee beans with
a 'Roasted On' date and consume
between 5-20 days after that date.
EN
®
®
27