Functions; Installing The Water Filter; First Use - Sage the Barista Express BES875 Kurzanleitung

Functions

INSTALLING THE WATER FILTER

• Remove the water filter and water filter holder
from the plastic bag.
• Soak the filter in cold water for 5 minutes.
• Wash the filter holder with cold water.
• Set the reminder for next month of replacement.
We recommend to replace the filter every
3 months.
• Insert the filter into the two parts of the
filter holder.
• To install the assembled filter holder into the
water tank, align the base of the filter holder
with the adapter inside the water tank.
Push down to lock into place.
8
• Fill the water tank with cold tap water before
sliding back into position at the back of the
machine and locking into place.

FIRST USE

• Ensure the water filter is securely fitted inside
the water tank.
• Fill the water tank with cold water up to the
MAX mark.
• Ensure the hopper is locked into position.
• Plug the power cord into a 230V power outlet.
Press the POWER button to switch the machine
on. The POWER button light will flash while the
machine is heating.
• Place a large heat proof bowl under the group
head.
NOTE
If the hopper is not correctly locked into position,
the FILTER SIZE LED's will flash.
1. Press 2 CUP button to run hot water through
the group head.
2. Position the steam wand tip over the drip tray.
Rotate the STEAM / HOT WATER dial to the
STEAM position and run steam through the
steam wand for 10 seconds.
3. Rotate the STEAM/HOT WATER dial
to the HOT WATER position and run water
through the hot water outlet for 10 seconds.
4. Repeat steps 1-3 until the water tank is empty.