VOLTCRAFT SDM-2125 Bedienungsanleitung Seite 41

• Press the up button
value. Confirm your selection with the confirmation button (4).
• Press the up button
value. Confirm your selection with the confirmation button
single-point measurement.
• Measure a point on the measured object. The LC display (2) shows 'PASS' or 'FAIL' accor-
ding to the setting. If 'PASS' is displayed, the tested workpiece is good. If 'FAIL' is displayed,
the workpiece is a reject or needs to be reworked.
Nominal value with
• Press the button
• Press and hold the button
Setting and taking the average measurement
1
Average measurement takes three measured values at three nearby points and averages them.
This average value is then evaluated as good or reject. Set the required value (100 µm in the
example) for the layer thickness and the permissible upwards and downwards tolerance (10 µm
in the example).
3 v
2v
(7) and down button
(7) and the down button
Measured Pass/Fail Mode:
value
tolerances
T
(5) to return to single-point measurement and continue measuring.
(5) to exit single-point measurement and stop measuring.
3 v
3v
(6) to select the desired layer thickness
(6) to select the desired tolerance
(4) to start measuring with
Result (good/
reject)
Fe
Substrate
material
Unit of thickness
41