Meat Probe (Autocook); General Operating Notes - KKT KOLBE EB8016ED Benutzerhandbuch

Programming

Meat probe (AutoCook)

The meat probe monitors the temperature inside a dish
(core). For this, a target temperature is determined.
When it has been reached, the dish is considered ready
and the oven switches off automatically.
• In standby mode, connect the meat probe to the socket in
the cavity. „Prob" and the probe icon
• Select your desired heating type using the
• Press to confirm the setting .
• After that, press the and
temperature.
• Press the key again to confirm the setting.
• The small display will show the temperature and the large
display „Prob".
• When the set target core temperature is reached, this will
be shown on the display.
Five beeps will signal the end of the cooking process.
Hints:
• The target core temperature can be set in the
range 50 - 150 °C. The operating temperature of
the oven is 165°C.
• While using this function, the automatic timer
cannot be set.
• If you unplug the meat probe from the socket, the
current operation will be canceled.
• If the display shows „ER-3" after the programme
has been started, this means a problem with the
meat probe. Please contact a qualified technician.
will be displayed.
and keys.
keys again to adjust the

General operating notes

• The oven light is turned on in all heating modes except the
ECO-Funktion.
• When you have selected a heating type, but the
is not pressed within 5 minutes, the current time will be
displayed (waiting state) and the selected function will be
recognized as invalid.
• To make sure that your input was detected right from the
SensorTouch-Control panel, a buzzer will sound.
Start / Pause / Cancel + Standby
• Start:
• Pause:
• Cancel + Standby: 2 times
Hint:
Press the key briefly to interrupt the cooking
process. A long press will be recognized as invalid.
key
45