Service Menu - Cameo OPUS SP5 PLUS Bedienungsanleitung

SERVICEMENU
Starting from the main display, press ENTER to enter the main menu. Use the UP and DOWN
control fields to select the Service menu and press ENTER.
This takes you to the submenu for editing the submenu items (select with UP and DOWN, confirm
with ENTER, change value with LEFT and RIGHT, confirm with ENTER).
Calibrate - Calibrate the components with values from 000 to 255 (password 050).
Test Manual - Manual testing of the components with values from 000 to 255.
Reset Motor - Reset the motors. All = All motors, Pan&Tilt = Pan and Tilt motors,
Head Only = Motors in the unit head.
USB Update - Firmware update via USB interface. OFF = Block firmware update via USB
interface. ON = Allow firmware update via USB interface.
Factory Reset - Reset to factory settings.
DEVICE INFORMATION (Info)
Starting from the main display, press ENTER to enter the main menu. Use the and controls to
select the information menu Info and press ENTER.
This will take you to the submenu for reading the device information (select with and , confirm
with ENTER).
System Info
Function error display
Error info If a fault is not corrected by a reset or restart, the defective unit must be repaired by
an authorised service centre.
Tempera-
Temperature display
ture
Head xx°C/F°
Base xx°C/F°
Temperature display in degrees
Unit
Celsius or Fahrenheit
21