Usb Interface - Cameo OPUS SP5 PLUS Bedienungsanleitung

11

USB INTERFACE

USB interface for updating the device firmware. In the Service menu, set the status for USB
update to ON. When available, download the latest firmware from the product page at www.
cameolight.com, unzip it and copy the files to a folder without special characters on a USB stick.
Disconnect the Moving Head from the mains and all input connections (DMX / Ethernet), connect
the USB stick to the USB interface and reconnect the Moving Head to the mains. The USB stick is
automatically recognised and shown in the display. Now navigate to the corresponding folder on
the USB stick and confirm with ON. The update procedure begins. Do not remove the USB stick or
disconnect the Moving Head from the mains during the update procedure.
The battery-powered display can be activated, even if the device is not connected to the mains. To
do this, press and hold MODE for approximately 3 seconds. You can now access device informati-
on to change and save system settings without mains connection. External control of the spotlight
is not activated in this case. For this reason, the display shows that there is no DMX signal even if
a DMX signal is available at the device.
12 PAN LOCK
Mechanical locking device used to prevent the rotation of
the head in the horizontal direction during transport. Dis-
connect the unit from the mains, move the head parallel
to the base (4 possible positions) and push the locking
lever in the direction of the pan rotation axis to lock it in
position. Unlock the device before startup.
13 TILT LOCK
Mechanical locking device used to prevent the rotation
of the head in the vertical direction during transport (7
positions). Disconnect the unit from the mains and slide
the locking lever in the direction of the tilt rotation axis,
moving the head of the unit vertically until one of the 7
locking positions is found and the locking lever engages.
Unlock the device before startup.
14
13
12