Cocraft HA 125 Original Bedienungsanleitung Seite 7

• Hold the power tool steady and position your arms and body so that you can
adequately handle any kickback. Always use the side-handle if there is one for
maximum control during kickback and to be able to control the torque produced
by turning the angle grinder on. Kickbacks or reactions to torque can be controlled
by the user if the required safety precautions are followed.
• Never place your hand near the rotating accessory. The accessory can be thrown
back onto your hand.
• Do not stand in the area in which the power tool could possibly end up if it were
to kick back. A kickback forces the tool in the opposite direction of the grinding
wheel's rotation.
• Be extra careful when working on corners, sharp edges, etc. Avoid bouncing
along and getting the accessory stuck. Corners, sharp edges, and bouncing have
a tendency to get the rotating accessory stuck and lead to loss of control
of the tool.
• Never fit a circular saw wood cutting blade or other toothed saw blade.
Such blades frequent lead to kickbacks and loss of control.
Specific safety precautions for grinding and cutting
with a cut-off wheel
• Only use those types of disc/wheel which are recommended for the power tool
and a special shatter guard plate designed for the selected cut-off wheel. Disc/
wheels which are not designed for use with the power tool cannot be properly
protected against and can be dangerous.
• The shatter guard must be fitted to the power tool correctly and adjusted to
provide maximum safety so that the user is exposed to as little of the disc/wheel
as possible. The shatter guard helps to protect the user from shards of shattered
disc/wheel and unintentional contact with the disc/wheel.
• The wheels/discs must only be used for the recommended work task. For
example: Do not grind with the edge of a cut-off wheel. Cut-off wheels are
intended for cutting using the edge. If force is exerted on the face, they can break.
• Always use undamaged flanges of a correct size and shape for the wheel you have
selected. Correct flanges support the wheel and minimize the risk of it breaking.
Flanges for cut-off wheels can be different from those which are used for grinding
discs.
• Never use worn-down wheels designed for use with a larger power tool.
Wheels intended for larger power tools do not have the same speed rating
as those intended for use with smaller tools and can shatter.
7