Cocraft HA 125 Original Bedienungsanleitung Seite 5

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits, etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
a) Repairs and service should only be performed by qualified tradesmen,
and only with original spare parts. This guarantees that the safety of the power
tool is maintained.
Special safety warnings applicable to grinding, dressing,
brushing, or cutting
• This power tool is intended for grinding, dressing, brushing and cutting. Read all
safety warnings, instructions, illustrations, and specifications that are included
with this tool. Neglecting to follow all of the instructions listed below can result in
electric shock, fire and/or serious injury.
• Polishing is not recommended with this power tool. The use of this power tool
to perform tasks for which the tool was not intended, can lead to danger and
personal injury.
• Do not use accessories which are not intended to be used with this tool and which
are not recommended by the manufacturer. Even if the accessory can be attached
to your power tool, there is no guarantee that it can be used safely.
• The accessory's rated speed must at least correspond to the power tool's
maximum rated speed. Accessories which rotate faster than their rated speed can
break and shatter.
• The accessory's outer diameter and size must fall within the rated capacity of your
power tool. If an accessory is the wrong size, it will not fit the guard and will not be
able to be controlled properly.
• The spindle size of the wheels, flanges, and backing plates or other accessories
must fit the spindle on your power tool correctly. Ill-fitting/incorrectly sized accessories
will end up out of balance, vibrate violently, and may lead to loss of control.
• Do not use damaged accessories. Inspect the accessory and make sure there are
no splits or cracks in the grinding wheels; cracks or wear and tear on the backing
plates, or loose or torn bristles on the steel brush wheels. If you drop your power
tool or accessory, check for damage. If the accessory is damaged, use a new/
undamaged accessory. After inspecting the tool and attaching an accessory, keep
yourself and others outside of the power tool's danger zone and let it run at full
speed for one minute. Damaged accessories will normally break during this test
period.
5