Panasonic AW-E750 Handbuch Seite 39

Sharpness (DTL) Set Display
4
1. Detail Select Setting
[DTL Select: Normal, Super DTL]
If contour correction is not sufficient at the Normal
position when Detail Level setting is set to LOW or
HIGH, select the Super DTL position.
Note
Neither Normal nor Super DTL is valid for con-
tour correction if Detail Level setting is in the
OFF position.
2. Detail Level Setting [Level: OFF, LOW, HIGH]
Detail level can be adjusted when Detail Select set-
ting is at Normal. Super DTL level can be adjusted
when it is at Super DTL.
In case of using the RCU (RCB), the above can be
adjusted with the contour correction switch (DTL).
RCU (RCB)
3. Noise Suppress Level Setting
[Noise Suppress: OFF, LOW, HIGH]
Screen noise can be reduced when Detail Level set-
ting (4-2) is at HIGH or LOW.
4. Clean DNR Setting [Clean DNR: HIGH, LOW, OFF]
This enables the clean DNR effect to be selected.
5. 3D-DNR Setting [3D-DNR: OFF, Low, Mid, High]
This enables the 3D-DNR effect to be selected.
When "Mid" or "High" is selected, the noise is
reduced but lag increases.
6. Flesh DTL Level Setting
[Flesh DTL Level: LOW, MID, HIGH]
LOW: The roughness of the flesh tones is minimized.
MID: This is the standard setting.
HIGH: The outline compensation for the flesh tones is
DTL Switch
-38 (E)-
accentuated.