Panasonic AW-E750 Handbuch Seite 25

Minimize the carrier wave using
the red & blue gain controls
Waveform for white
balance set chart
RESET TO 3 200K OR 5 600K WHITE
BALANCE
When the white balance setting is set to either "P SET
3 200K" or "P SET 5 600K" the white balance will be
automatically set to the colour temperature 3 200K or
5 600K, respectively.
BLACK BALANCE ADJUSTMENT
• Close the lens.
If the motor drive lens is controlled from the camera,
the lens is automatically closed when the black bal-
ance is adjusted.
• When the camera is used without a RCU or RCB,
R/B pedestal adjustment of painting setting will be
automatically reset to ±0 after setting the black bal-
ance. (painting setting in only USER MODE.)
[ADJUSTMENT by CAMERA]
Press the YES/ABC Switch for over 2 seconds and the
black balance will be set automatically in 10 seconds.
In user mode, black balance fine adjustment can be
performed with the red pedestal/blue pedestal setting
after setting the black balance.
[ADJUSTMENT with the RCU (RCB, Hybrid control
panel)]
Set the AUTO set switch to ABC and the black balance
will be automatically set. While the system is being set,
the auto warning indicator (LED) blinks and it goes out
when the black balance setting is completed. If the
lamp remains lit, ABC should be tried again.
YES/ABC Switch
AUTO LED
AUTO Set Switch
ABC
-24 (E)-