Husqvarna 540XP Mark III Bedienungsanweisung Seite 228

3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the screw and washer (A) and remove the
pulley (B).
A
B
6. Hold the starter rope handle.
228
7. Pull the starter rope until 1 cm of the spring guide
is shown. At the same time, press down the starter
handle cover and remove it from the starter rope
handle.
Note:
If the starter rope is broken in the starter
rope handle, push the starter handle cover down.
Use the combination wrench to remove the starter
handle cover.
8. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
9. Connect the pulley to the recoil spring. The end of
the recoil spring must engage in the pulley.
10. Attach the screw to the center of the pulley.
11. Pull the starter rope through the hole in the starter
housing, the starter rope handle and the spring
guide.
12. Make a knot 1 cm/0.5 in (A) from the end of the
starter rope.
13. Put the rope end or the starter rope parallel to the
knot.
1 cm/0.5 in
1679 - 006 -