10 IECEx Certificate of Conformity
Certificate No.:
IECEx ZLM 14.0011X
Date of issue:
2023-04-27
EQUIPMENT:
Equipment and systems covered by this Certificate are as follows:
The temperature head transmitter JUMO dTRANS T01 Type (956555)/707015/... is used for the measurement and signal conversion of
resistance thermometers, thermocouples, resistance-type sensors and voltage sensors in a 4...20 mA current loop. The current input loop and
signal output are freely scalable via an interface. The measured value registration is realized by A/D conversion. The registered data are
evaluated via a D/A converter as a measurement signal in the 4...20 mA current loop. The available galvanical isolation is a function isolation
between sensor circuit and supply circuit.
The temperature head transmitter can be used in the hazardous location. The temperature head transmitter is to be installed in a way which
guarantees protection IP20 according to IEC 60529 at least for all connectors as well.
SPECIFIC CONDITIONS OF USE: YES as shown below:
1. The configuration via the setup circuit is only permitted in non-hazardous locations. In this case, none of the connections may be laid into
the hazardous location.
3. The head transmitter is to be installed in such a way, that no electrostatic charge is possible.
4. The instruction manual has to be observed, in particular with regard to the consideration of lesser ambient temperatures during the
application in accordance with category 1.
IECEx Certificate
of Conformity
31
Page 3 of 4
Issue No: 2